No announcement yet.

1/4 barrel Coors Light Foam

  • Filter
  • Time
  • Show
Clear All
new posts

  • psychodad
    What Iceman suggested should work. And you won't so much ruin a keg by making it go flat, because it will re-carbonate to the correct amount the same way it over carbonated. And if this is the Danby original equipment regulator, this will likely happen again. The MicroMatic dual gauge premium regulator is the best thing I did to my kegerator.

    Leave a comment:

    The pressure issues are not my expertise but I believe what you can do if you feel you over carbonated your keg is to shut off the pressure to the keg, pull the pressure relief valve on the coupler to bleed some pressure off, shake the keg a bit & bleed it off again. Go ahead & turn the pressure back on & set your regulator where it needs to be. Your temp looks good so, as long as you get the pressure correct this time around you should be fine.


    Leave a comment:

  • Acousticcountry
    started a topic 1/4 barrel Coors Light Foam

    1/4 barrel Coors Light Foam

    Hey guys,

    I'm sure by now everyone is tired of questions about foam, but here's what I've got.

    Danby Kegorator
    8-10 ft 3/16"ID beer line
    Coors Light 1/4 bbl Keg
    2900' elevation
    90% foam.

    I think I may have accidentally over carbonated this beer. When I hooked it up,l and turned on the co2 it was showing around 14 psi.. Had a few beers and it poured well. I came back a few days later and it was sitting at about 20 psi. If it was at 20 psi for several days could that have over carved the beer? I have turned down the pressure but also don't want to end up ruining the keg by making it go flat. I am going to go get a new thermometer as the one I had broke, but I am pretty sure the beer temp is around 34-35. (I have changed the capacitors in the thermostat to get the Danby to cool more.)

    What should I do to fix this?

    Any help is appreciated!